Spindle cutter – 3 lip classic bead

Tungsten Carbide – 3 wing

The cutter is designed to be used with a stationary spindle moulder equipped with either a 3/4′ or 1/2′ spindle shaft.

The cutter can be configured to cut quarter rounds and coves

KP800020 – 3/4′ – 1/2′ spacer rings

Important:

• Make sure the spindle moulder has a table opening of at least 140mm.
• Designed for spindle moulders equipped with either a 1/2′ or 3/4′ spindle shaft.

To use spindle cutters safely (and to get the best results from your spindle), the cutters need to be installed properly on the spindle shaft. Improper installation of your cutter can cause excessive chatter and could increase the likelihood that the bits will break when in use. There is also a risk of having the cutter ‘cold welded’ to the spindle shaft.

First of all, before beginning any moulding operation, check your cutter to make sure that it is clean and most of all, sharp. If the bit is dull, chipped, is excessively burnt or has any other defect, it should be sharpened or replaced before use.

KP708010Router Bits > Spindle Cutters